Menzerna Power Finish PO 203 is formulated for all clear coats. It addresses the most common paint condition on the most common paint on the road today. Power Finish is an everyday detailing product. It removes the light to mid-range imperfections that plaque most vehicles and then leaves a silky smooth gloss. Menzerna Power Finish PO 203 and a wax are often all you need to restore a deep gloss to the paint.

Menzerna Power Finish PO 203 contains Menzerna’s uniform, finely milled abrasives. The polish is packed with a high concentration of abrasives to level imperfections effectively without marring. Therefore, you can achieve a high gloss shine in fewer steps… and with fewer polishes!

Menzerna Power Finish PO 203 is a silicone-free, low-dusting polish. It is body shop safe and easy to clean up. Just like all Menzerna polishes, Power Finish should be applied with a polisher for best results. We recommend using a polishing pad.

Whether you’re a professional detailer, auto refinisher or an enthusiast, Menzerna Power Finish PO 203 saves you time and money by creating a mirror shine in less time and with fewer polishes. One polish, one step, one fantastic result. Menzerna Power Finish PO 203 is the only polish you need.

Use a white or green pad to apply Menzerna Power Finish. The density of the foam will help level imperfections.

The FLEX XC 3401 VRG Orbital Polisher has the right balance of speed and safety to polish the paint without marring.

Apply the polish to the pad and spread over the paint with the machine turned off to prevent splatter. When you're ready, work the polish side to side and up and down until a nice gloss appears.

Application by Machine:

1. Make sure the surface to be polished is clean and dry. Fresh paint should be fully cured. Apply Menzerna Power Finish PO 203 out of direct sunlight.
2. Use a soft foam polishing pad, like Lake Country’s CCS White Polishing Pad or Green Polishing/Finishing Pad. Apply a bead of Power Finish to the pad. With the polisher turned off, spread the polish over about a 2 x 2 sq. ft. area.
3. Polish at 1500-2000 RPM (4-5 on a dual action polisher) working slowly across and then up and down the area. Check your work after several passes to see if the swirls have been removed. If so, reduce the pressure and continue buffing until a high gloss is achieved. If the pad becomes dry, mist it with water and continue buffing.
4. Wipe the area with a damp Cobra Microfiber Towel.
5. Always apply a wax or sealant after polishing. We recommend Wolfgang Deep Gloss Paint Sealant 3.0 to seal in the shine with its long-lasting polymer formula.

128 oz.