CARPRO Lift Snow Foam 500 mL

If you have heavy or stubborn debris on a car, it may take more than shampoo to remove it. CARPRO Lift is a professional alkyl snow foam pre-wash that softens the grime and “lifts” it off the surface so it’s easier to remove during the main wash. By letting the high-pH foam soak into dirt, pollen, road grime and bugs, you won’t need to scrub as hard, which means a lower risk of scratching your prized paint. When diluted to the recommended 1:10 ratio, you also can use Lift snow foam to remove old waxes and sealants. And there’s no underestimating how fun it is to spray a car down with foam.

Easily Lift Away Dirt

This touchless car cleaning foam is an active surface agent that can be used with most foam cannons and sprayers for easy application. Once it’s sat for a minute or two, use a high-pressure hose or power washer to rinse it off. Or get out your favorite wash mitt and turn CARPRO Lift into a single-step car wash. When diluting it for your car cleaning gun, use a mixture thicker than 1:10 if you want denser, more powerful foam or a thinner mixture to get better flow. See the Directions below for more information about best practices.

We offer several sizes of Lift pre-wash foam bottles and jugs so you can get the right amount for your shop. Using foam for the first time? Watch our step-by-step guide to cleaning with a foam gun. Autogeek is an authorized CARPRO dealer with the knowledge you need for any detailing project.

Directions:

How to use a Pre-Wash:

1. Use only on cool surfaces. Do not use in direct sun. Do NOT allow to dry on surface.
2. Dilute Lift with water (we recommend 1:10). You can use leaner ratios for a more flowing mixture or a richer ratio for a denser foam.
3. Allow the product to remain on the surface for a minute or as long as possible without allowing too dry.
4. Power rinse off. This completes your Lift Pre-Wash.
5. Wash with CARPRO Reset.

How to use as Single Wash Solution:

1. Use only on cool surfaces. Do not use in direct sun. Do not allow shampoo to dry on the surface!
2. Pre-rinse vehicle with free-flowing water to remove loose debris
3. Dilute Lift with water (we recommend 1:10). You can use leaner ratios for a more flowing mixture or a richer ratio for a denser foam.
4. Allow the product to remain on the surface for a minute and then wash from the top down using our favorite wash mitts.
5. Its critical to rinse your mitt or sponge periodically in a second bucket filled with clear water or with a hose.
6. After washing, rinse the vehicle thoroughly with free-flowing water to remove shampoo residue, and dry with a microfiber towel.